Novinka:Toshiba: 5V ARM Cortex™-M3 (IEC60730)
(Kategória: Semiconductor-ZONE)
Zaslal EdizonTN
08.03.2010-13:04
Spoločnosť TOSHIBA Electronics Europe GmbH, predstavila nový mikroprocesor určený predovšetkým pre použitie v v priemysle a v domácich spotrebičoch (je v súlade s bezpečnostným štandartom IEC60730).
Jedná sa o TMPM380FY. Je to jadro ARM Cortex™-M3, s FLASH pamaťou 256kB a RAM 16kB, zabalené v 100-pinovom QFP, alebo LQFP púzdre.
Vlastnosti
- ARM Cortex-M3 microcontroller core
- New 16-bit Thumb® instructions for improved program flow
- New 32-bit Thumb instructions for improved performance
- Auto-switching between 32-bit instruction and 16-bit instruction is executed by compiler.
- A 32-bit multiplication (32×32=32 bit) can be executed with one clock
- Division takes between 2 and 12 cycles depending on dividend and devisor
- Optimized design using a low power consumption library
- Standby function that stops the operation of the microcontroller core
- An interruptible long instruction
- Stack push automatically handled by hardware
- Interrupt source
- Internal: 77 factors…The order of precedence can be set over 7 levels (except NMI).
- External: 16 factors…The order of precedence can be set over 7 levels
- Input/ output ports 85 pins
- Input/Output: 84 pins Output: 1pin
- Watchdog timer (WDT): 1 channel
- 26 cycles of binary counter
- Watchdog timer out
- Power_On reset function (POR)
- Voltage detection circuit (VLTD)
- Oscillation frequency detect function ( OFD)
- DMA contorller: 2 channels
- Incr to Incr / Incr to No-Incr / No-Incr to Incr / No-Incr to No-Incr
- 4word FIFO buffer for each channel
- Scatter/gather transmission support
- Encoder input circuit (ENC): 2 channels
- Correspond to increamental encoder(AB/ABZ)
- Rotation direction detecttion
- Counter for absolute position detection
- Comparator for position detection
- Noise filter
- 3 phase sensor input
- 16-bit Multi Puropose Timer (MPT) : 3 channels
-Channel 0/1: Supported for PMD fucntion / IGBT function / 16bit timer function
-Channle 2: Supported for IGBT function / 16bit timer function
- 16-bit timer (TMRB): 8 channels
- 16-bit interval timer mode
- 16-bit event counter mode
- 16-bit PPG output
- Input capture function
- Real time clock (RTC)
- Clock (hour, minute and second)
- Calender (Month, week, date and leap year)
- Alarm (Alarm output)
- Alarm interruption
- General-purpose serial interface(UART/SIO): 5 channels
- Either UART mode or synchronous mode can be selected (4byte FIFO equipped)
- Serial bus interface (I2C/SIO): 2 channels
- Either I2C bus mode or synchronous mode can be selected
- Synchronous serial Port (SSP): 2 channels
- SPI flame format /SSI flame format /Microwire flame format
- 16byte FIFO equipped ( 16bit x 8 )
- Remote control signal preprocesser (RMC) : 1 channel
- Can receive up to 72bit data at a time
- 12-bit A/D converter (ADC): 1unit (18 channels for analog input)
- Start by the internal trigger: TMRB interrupt / PMD trigger
- Single/repeat mode
- Conversion speed 2.0usec (@ ADC conversion clock = 40MHz)
- Standby mode
- Standby modes: IDLE, SLEEP and STOP
- Sub clock operation (32.768KHz): SLOW, SLEEP
- Clock generator(CG)
- External Osciillator (High Freq. 10MHz X’tal/Ceramic) or On-chip Oscillator (10MHz)
- External Oscillator (Low Freq. 32HKz X’tal)
- On-chip PLL (4 times)
- Clock gear function: The high-speed clock can be divided into 1/1, 1/2, 1/4, 1/8
- Endian
- Little endian
- Maximum operating frequency
- 40MHz
- Operating voltage range
- 4.5V~5.5V (with on-chip regulator)
- Temperature range
- -40°C~85°C (except during Flash writing/ erasing and debugging)
- 0°C~70°C (during Flash writing/ erasing and degugging)
Blokové zapojenie
TMPM380FYFG: 256kB FLASH; 16kB RAM; LQFP100
TMPM380FWFG: 128kB FLASH; 8kB RAM; LQFP100
TMPM382FWFG: 128kB FLASH; 8kB RAM; LQFP48
TMPM382FSFG: 64kB FLASH; 8kB RAM; LQFP48
Odkazy
Homepage
Datasheet
Distribúcia
viď. Adresár
Táto novinka je z mikroZONE
( http://www.mikrozone.sk/news.php?extend.407 )